分页: 1 / 1

bow mount的trolling 可以改为transom mount吗?

帖子发表于 : 22 7月 2014 14:14
folinc
另外买二手的电马达有没有什么讲究?谢谢

Re: bow mount的trolling 可以改为transom mount吗?

帖子发表于 : 22 7月 2014 14:40
creativeccc
folinc 写道:另外买二手的电马达有没有什么讲究?谢谢


bow mount的贵那么多,你直接买个TRANSOM MOUNT的不好?

Re: bow mount的trolling 可以改为transom mount吗?

帖子发表于 : 22 7月 2014 14:47
grandriver
不能吧?
bow mount的trolling motor买新的也不贵,二手的话kijiji上也不少。

我觉得没什么要注意的,接上电池能转就OK了。

Re: bow mount的trolling 可以改为transom mount吗?

帖子发表于 : 22 7月 2014 15:12
folinc
creativeccc 写道:
folinc 写道:另外买二手的电马达有没有什么讲究?谢谢


bow mount的贵那么多,你直接买个TRANSOM MOUNT的不好?


看到一个bow mount的70lb 24v。200刀。想拿下,但是只能装到transom,所以有这个疑问

Re: bow mount的trolling 可以改为transom mount吗?

帖子发表于 : 22 7月 2014 15:16
Sergeantpepper
You'll have a direction issue....hard to mount a bow-mount type by the transom, you can only best side-mount it for proper deploying/stowing operation

Check propeller condition,
check prop RPM visually in response to different control settings
check the play between the shaft and the casing radially to see if the bearings are not overly worn....

Re: bow mount的trolling 可以改为transom mount吗?

帖子发表于 : 22 7月 2014 15:27
folinc
Sergeantpepper 写道:You'll have a direction issue....hard to mount a bow-mount type by the transom, you can only best side-mount it for proper deploying/stowing operation

Check propeller condition,
check prop RPM visually in response to different control settings
check the play between the shaft and the casing radially to see if the bearings are not overly worn....



谢谢

Re: bow mount的trolling 可以改为transom mount吗?

帖子发表于 : 22 7月 2014 16:05
Sergeantpepper
...check if the "in-line fuse" is there too

Re: bow mount的trolling 可以改为transom mount吗?

帖子发表于 : 23 7月 2014 10:01
folinc
Sergeantpepper 写道:...check if the "in-line fuse" is there too


这个inline fuse一般在什么地方?是在motor里面还是在cable上?
谢谢

Re: bow mount的trolling 可以改为transom mount吗?

帖子发表于 : 23 7月 2014 11:30
Sergeantpepper
You may find it along the electric input cable..
The trolling motor alone does not carry a circuit breaker, or fuse..
If the tr.motor is pre-rigged to the boat by the dealer then there must be a circuit breaker between the battery & the pedal controller..
A circuit breaker is vital, or you may burn the motor when the boat gets stuck in heavy covers..
There are in general 2 types of breakers, the thermal type which will auto reset after cooling down, the reset type need manual reset after cooling down..

If you ever need to add one, here's the rule of thumb for a 12V system... fuse Amp = thrust capacity of motor, e.g. use 40A fuse for a 40-lb Tr.Motor :fish1

Re: bow mount的trolling 可以改为transom mount吗?

帖子发表于 : 23 7月 2014 12:07
Ecstasy
图片

Re: bow mount的trolling 可以改为transom mount吗?

帖子发表于 : 23 7月 2014 12:14
folinc
谢谢楼上2位,这个breaker一般那里有卖,在marine吗?

Re: bow mount的trolling 可以改为transom mount吗?

帖子发表于 : 23 7月 2014 12:38
Sergeantpepper
http://www.lebaron.ca/pdf_files_sp13/mi ... access.pdf
http://www.amazon.com/MinnKota-MKR-19-C ... B001PTHKSK

Of couse you can also use the ordinary replaceable type..get it from CTire