由 Sergeantpepper @ Mon Dec 30, 2019 10:08 pm 写道:wetnose @ Mon Dec 30, 2019 6:33 pm 写道:Sergeantpepper @ Mon Dec 30, 2019 5:42 pm 写道:
the bottom one, 1/4" not M6...you just forced it through the M6 female threads on the auger shaft or what ? or you had drilled away the female threads making it a through hole to let this 1/4" screw go through ?
( the O.D. of the 1/4" male threads is smaller than 1/4", and may just go through a M6 hole)
下面的一个是用来替带这个螺丝的。1/4" and M6是不能混用的。
最初沒見到那绿色extension 图....
鵝gas auger 有用D-shape quick release lock pin 去代替这口螺絲，方便載运时跟power head 快速装卸，但因要通过那些female threads所以只能用較細口径的pin，除非决心把耶些female threads 弄走，但也沒用这重家伙了
谢谢辣sir！
我一直在为我的充气船的上下船的轮子找这个lock pin，可惜一直没有找到合适的，于是在CT买了这种在用。
https://www.canadiantire.ca/en/pdp/motomaster-square-latch-pin-1-4-in-0406958p.html?rrec=true#spc
但是，我copy & paste 你的"D-shape quick release lock pin" 到Google，一下子就找到了我一直想找的，得来全不费工夫啊！
